The HTR-5250 is a 5-channel receiver providing Dolby Digital and DTS decoding, Dolby Pro Logic processing and Yamaha's Digital Sound Field Processing, Cinema DSP and Tri-Field Processing.
The most advanced and realistic encoded surround sound for movies from Dolby Laboratories. The new Dolby Digital system is a fully discrete system providing six channels of sound. Five are full-frequency channels, and the sixth is a low frequency effects channel.
Like Dolby Digital, DTS is a discrete 5.1 channel system. It uses a higher bit-rate for greater resolution and is available on DVDs, laser discs and music CDs.
Yamaha's exclusive Tri-Field Processing which applies Digital Sound Field Processing technology to Dolby Digital and DTS to create a true movie theater experience in the home. It develops independent enhanced sound fields for the front signals as well as for left and right surround.
Discrete power transistors rather than IC chips are used in the amplifier section to provide the cleanest sound possible. The amp delivers 100 watts to all five channels.
New digital-to-analog converters with 96 kHz/24-bit capability assure that the HTR-5250 can handle all digital audio formats and data with complete fidelity.
Yamaha's YSS-918 chip provides Dolby Digital and DTS with full channel separation and no front-to-back bleedthrough. In addition to the chip creates Yamaha's Music and Cinema DSP and Tri-Field Cinema DSP modes.
Yamaha's exclusive Digital Sound Field Processing for music recreates the acoustic personalities of actual concert halls and other venues, such as the Roxy Theatre in L.A., Village Gate in N.Y., Anaheim Stadium and concert halls and churches in Europe. Cinema DSP multiplies the effects of Dolby Pro Logic and Yamaha DSP to provide the best possible Pro Logic movie theater recreation in your home. Tri-Field Processing DSP does the same for Dolby Digital and DTS.
The HTR-5250's rear panel has input jacks to accommodate an external 6-channel decoder. So the receiver is ready for any other 5.1 channel format, should one be developed.
The HTR-5250 can accommodate three digital sources. The jack panel has three optical digital and two coaxial digital inputs.
The HTR-5250 is a versatile receiver incorporating three sets of audio-only inputs and 5 pairs of A/V inputs. All the video inputs have RCA jacks and 5 S-video inputs. Includes one set of A/V inputs on the front panel for fast and easy connection. In addition, the HTR-5250 provides S-video and composite video output.
S-video output jacks for TV Monitor and VCR assure the best quality video pass-through.
When different input formats are connected from the same source, the HTR-5250 automatically prioritizes them and selects in order DD, DTS, PCM, and finally the analog input.
The HTR-5250 senses a Dolby Digital or DTS signal and will automatically switch the receiver to that mode when the signal is detected.
The advanced remote control with the HTR-5250 has luminescent keys and preset codes for most brands of VCRs, TVs, etc.
Yamaha's famed low impedance drive circuitry is included in this receiver so that it can handle virtually all loads and a wide variety of speakers. For further speaker matching, the receiver's back-panel switches can be set for either 4- or 8-ohm speakers.
The advantage of full range, 20 to 20,000 Hz, damping is that it improves the defiition and resolution of the sound output throughout the audible frequency range.
Allows selection of either a first set of speakers or a second -- or both.
Permits a delayed receiver turn off. You can set it for up to two hours in 30 minute increments.
Up to 40 preset AM and FM stations can be grouped in five groups eight stations. These groupings make it easy for family members to easily access their favorite stations or to have musical genres, such as all the jazz stations, grouped together.
Yamaha's heavy-duty binding post speaker terminals accept banana plugs, spade connectors, and a variety of speaker wire, including heavy gauge cable.
Minimum RMS Output Power per Channel | MAIN, 20Hz-20kHz, 0.06% THD, 8 ohms...100W + 100WCENTER, 20Hz-20kHz, 0.06% THD, 8 ohms...100WREAR, 20Hz-20kHz, 0.06% THD, 8 ohms...100W + 100W | |
---|---|---|
Dynamic Power per Channel | MAIN, 8/6/4/2 ohms...130/150/190/240W | |
Dynamic Headroom | 8 ohms...1.14dB | |
Damping Factor (8 ohms, 20 Hz-20 kHz) | MAIN L/R, 80 | |
Input Sensitivity/ Impedance | PHONO MM...2.5mV/47k ohmsCD, etc...150mV/47k ohms | |
Maximum Input Signal Level | PHONO MM, 1kHz, 0.05% THD, (Effect on)...100mVCD, etc (Effect on)...2.2V | |
Output Level/ Impedance | REC OUT...150mV/1.2k ohmsPRE OUT (MAIN < etc)...2.1V/1.2k ohmsSUBWOOFER (EFFECT OFF, MAIN SP:SMALL)MONO...4.0V/1.2k ohms | |
Headphone Jack Rated Output/Impedance | CD, etc, (150mV, 8 ohms)...340mV/560 ohms | |
Frequency Response (10Hz-100kHz) | CD, etc, MAIN L/R...+0/-3.0dB | |
RIAA Equalization Deviation | PHONO MM...0 +/- 0.5dB | |
BASS | Boost/Cut...+/-10dB (50Hz)Turnover Frequency...350Hz | |
TREBLE | Boost/Cut...+/-10dB (20kHz)Turnover Frequency...3.5 kHz | |
Bass Extension | +6dB (60Hz) | |
Filter Characteristics | SUBWOOFER OUT: LPF...fc=90Hz, 18dB/octMAIN, CENTER, REAR SP SMALL: HPF...fc=90Hz, 12dB/oct | |
Total Harmonic Distortion (20Hz-20kHz) | PHONO MM to REC OUT (1V)...0.02%CD, etc, to MAIN SP OUT L/R (1V)...0.06% | |
Signal-to-Noise Ratio (IHF-A-Network) | CD, etc, Input Shorted (Effect off)...99dB | |
Residual Noise (IHF-A-Network) | MAIN, SP OUT...150uV | |
Channel Separation (Vol.-30dB, Effect off) | PHONO MM, Input Shorted, 1kHz...60dBCD, etc, Input 5.1k ohms Shorted, 1kHz...60dB | |
Muting | - infinity | |
Video Signal Type | NTSC | |
Composite Video Signal Level | 1Vp-p/75 ohms | |
S Video Signal Level | Y...1Vp-p/75 ohmsC...0.286Vp-p/75 ohms | |
Component Signal Level | Y...1Vp-p/75 ohmsCb/Cr...0.7V/75 ohms | |
Video Maximum Input Level | 1.5Vp-p | |
Video Signal-to-Noise Ratio | 50 dB | |
Monitor Output Frequency Response | Composite Video Signal...5Hz-10MHz, -3dBS-Video Signal...5Hz-10MHz, -3dBComponent Signal...DC-30MHz, -3dB | |
Tuning Range | 87.5 to 107.9MHz | |
50dB Quieting Sensitivity (IHF, 75ohms) | Mono (1kHz, 100% Mod)...1.6uV (15.3dBf)Stereo (1kHz, 100% Mod)...23uV (38.5dBf) | |
Selectivity (400kHz) | 75dB |
Signal-to-Noise Ratio | Mono/Stereo (IHF)...81/75dB |
---|
Harmonic Distortion | Mono/Stereo (1kHz)...0.1./0.2% | |
---|---|---|
Stereo Separation | 1kHz...48dB | |
Frequency Response | 20Hz-15kHz...+0.5/-2.0dB | |
Output Level | FM 100% Mod. 1kHz...550mV | |
Antenna Input | 75 ohms unbalanced | |
Usable Sensitivity | 300uV/m | |
Antenna | Loop Antenna | |
Dimensions | Width = 17 1/8 in.Height = 5 15/16 in.Depth = 15 3/8 in. | |
Weight | 25 lbs. |
This item is used and will show signs of wear but is fully functional. All knobs turn smoothly and buttons click and release as they should. The only issue is one of the rear feet broke off and is missing. The screw is still there and the hole is not stripped or damaged. I used a roll of black electrical tape in its place.
You are receiving the exact one pictured. You will not be disappointed.
We only ship to U.S. so no international bidders, please. Item will be shipped with in 1-3 business days of receiving cleared PayPal payment.Therefore, the sooner you make your payment, the sooner you will receive your item. If there are any questions, please feel free to contact us. We do our very best to reply to any and all questions the same day they are received. Thank you and happy bidding!
Shipping / Handling Cost | Cost For Each Additional Item | Service |
---|---|---|
$45.00 | $0.00 | FedEx Ground or FedEx Home Delivery (1 to 5 business days) |